Call : 0086-21-58386256

properties for copper slag used as fine aggregate in concrete

Concrete with Copper Slag Fine Aggregate. | Request PDF

The use of copper slag in cement clinker production, and the effects of copper slag on the properties of Portland cement mortar and concrete in the form of cement replacement, coarse and fine ...

Study of Properties of Concrete containing Copper Slag as ...

The Slump test was conducted on fresh concrete for various percentage of replacement of fine aggregate with Copper slag and their results are tabulated below. Table 5: Replacement of sand by copper slag. Sl.No. % of fine aggregate % of copper slag replacement Slump value (mm) 1 100 0 73 2 80 20 77 3 60 40 83 4 40 60 87 5 20 80 92

PROPERTIES OF CONCRETE CONTAINING WASTE COPPER …

replacement of fine aggregate in concrete. This shows promise for developing an additional viable solution to tackle the issue of copper slag waste. Keywords: industrial solid waste management; copper slag aggregate; concrete properties 1. Introduction Copper slag (CS) is a waste material widely obtained from the industrial sector in the

Research Paper PERFORMANCE OF COPPER SLAG ON …

This paper reports on an experimental program to investigate the effect of using copper slag as a replacement of fine aggregate on the strength properties. Copper slag is the waste material of matte smelting and refining of copper such that each ton of copper generates approximately 2.5 tons of copper slag. Copper slag is one of the materials ...

Effect of copper slag as a fine aggregate on the ...

Al-Jabri investigated the effects of using copper slag as a fine aggregate on the properties of cement mortars and concrete, and he found that up to 40%-50% (by weight of sand) of the copper slag ...

Mechanical Properties and Durability of Concrete with ...

Jan 27, 2017· Concrete was made with a mix design of 1:1.5:3 (1 part cement; 1.5 parts sand and 3 parts coarse aggregate) according to British Standards guidelines for RC40 [].Two different sets of mixes were made with water/cement (w/c) ratios of 0.55 and 0.45 respectively, with the mix composition shown in Table 4.Mixes without copper slag were made to serve as control mixes.

Experimental Investigation on the Mechanical Properties of ...

concrete increased by 55% at 40% replacement of fine aggregate by copper slag, and up to 75% replacement, (Chavan et. al., 2013) concrete gain more strength than control mix concrete strength. Al-Jabri et al., investigated the effect of using copper slag as a fine aggregate on the properties …

SCOPE OF REPLACING FINE AGGREGATE WITH COPPER …

increasing the mechanical properties of concrete. The use of copper slag can be done up to 30% exceeding it's used beyond 50% decrease the strength. 4. Arivalagan. S (2013) Experimental Study on the Flexural Behavior of Reinforced Concrete Beams as Replacement of Copper Slag as Fine Aggregate

Study on Mechanical Properties and Durability Studies on ...

Copper slag Table 1.1 Physical properties of copper slag S Table 1.2 Chemical properties of copper slag 1.2 Preparation and testing of specimen M35 grade concrete was used to find out the test results. For that concrete specimens were prepared to find out …

Study of the Properties of Concrete Containing Copper Slag ...

Study of the Properties of Concrete Containing Copper Slag as a Fine Aggregate . Srinivas C. H1*, S. M Muranal2 1Department of Civil Engineering, Rural Engineering College, Hulkoti-588205 . 2Department of Civil Engineering, Basaveshwar Engineering College, Bagalkot-587102 . Abstract - Copper slag is one of the materials which is considered as waste materials in the production of copper,

Project Report on Copper Slag in Concrete

James G. Speight PhD, DSC, in Asphalt Materials Science and Technology, 2016. 1.5.1.6 Slag. Slag aggregates are obtained by crushing of smelter slag or by special treatment of fire-liquid slag melt (molten slag aggregates). Currently there are many types of concrete that are developed and used in construction that include metallurgical slags both as a binding component and as fillers.

Effect of Copper Slag as a Fine Aggregate on Properties of ...

— In this work, an extensive study using copper slag has been carried out to investigate strength, workability and durability. Copper slag is an industrial by-product material produced from the process of manufacturing copper. For, 2.2 tonnes of

Performance of Copper slag and ferrous slag as partial ...

replacement, CS and FS can be effectively used as replacement for fine aggregate. Further research work is needed to explore the effect of CS+FS as fine aggregates on the durability properties of concrete. Keywords: By product, copper slag, ferrous slag, compressive strength, concrete…

Concrete mix design using copper slag as fine aggregate

Nov 10, 2014· Its specific gravity is 3.91. The fine aggregates used for this work are Natural River sand and copper slag. The physical properties of fine aggregates such as sieve analysis, specific gravity, bulk density, percentage voids etc., were determined as per 10.

Partial Replacement of Copper Slag as Fine Aggregate

Copper slag Table.1.Cement Properties Table2.Fine Aggregate Properties Test Particulars Result Obtained Requirments As Per Is 12269-1970 Specific gravity 2.54 2.60 – 2.90 Fineness modulus 2.89 - Water absorption (%) 0.7% MAX 1% Table.3.Coarse Aggregate Properties Test Particulars Result Obtained Requirments As Per Is 12269-1970 Specific

copper slag used as a fine aggregate in concrete

Three slender reinforced concrete columns of 150x150x2500mm were tested for monotonic axial compression load until failure. The concrete mix included ordinary Portland cement, fine aggregate, 10mm coarse aggregate and copper slag. The ratios of copper slag to fine aggregate. Properties of Concrete Using Copper Slag as a Substitute

Fresh and mechanical properties of self compacting ...

An investigation is carried out on the development of Self Compacting Concrete (SCC) using copper slag (CS) as fine aggregates with partial and full replacement of sand. Six different SCC mixes (60% OPC and 40% Fly Ash) with 0% as control mix, 20%, 40%, 60%, 80% and of copper slag substituting sand with constant w/b ratio of 0.45

Study Of Properties Of Concrete Containing Copper Slag

slag construction primarily as aggregate in concrete mixtures. Fig -1 Copper Slag 1.3 BASIC PROPERTIES OF COPPER SLAG The slag is a black glassy and granular in nature and has a similar particle sie range like sand which indicate that it could be tried as replacement for the sand in cementites slag mixture. Read More

Use of copper slag as a replacement for fine aggregate in ...

The use of copper slag as a replacement for fine aggregate in construction will reduce damage to the environment due to the waste resulting from the copper manufacturing process and help in saving natural resources. In this research, the use of copper slag as a replacement for fine aggregate is investigated. Three slender reinforced concrete ...

Grading Of Copper Slag Aggregate With Fine Aggregate

201758 copper slag by replacing natural fine aggregate at different percentage like 0 20 40 60 80 and 100. B. Objective of the Investigation 1 The use of copper slag in the concrete as a replacement for fine aggregate reduces the costs of disposal lowers the cost of the concrete …

(PDF) Study on Mechanical Properties of Concreteon Partial ...

Concrete is the most popular building material in the world. It is the most consumable material after water. Concrete is a mixer of binding material, fine aggregate, coarse aggregate and water. Generally Ordinary Portland Cement (OPC) is used as a

can copper slag be grinded as fine aggregate

Effect of copper slag as a fine aggregate on the properties of concrete 325 obtained from Seowon Co., Ltd. The copper slag was ground in the laboratory into a fine powder of the required particle sizes. The ground slag was classified according to the average particle size into three types, as shown in Fig. 1. The gradation tests conducted on

COPPER SLAG IN CONCRETE AS REPLACEMENT MATERIAL | …

About 2.2 tonnes of copper slag is generated, for every ton of copper production. The primary objective of this paper is to study the application of copper slag as an alternative replacement material of sand. This paper also studies the effect of replacement of Fine aggregate with copper slag on mechanical properties of concrete.

Performance of Copper Slag on Strength as Partial ...

Concrete with copper slag fine aggregate, Society of Materials Science, Vol. 49, pp. 1097-1102. Arivalagan. S (2013):Experimental Study on the Flexural Behavior of Reinforced Concrete Beams as Replacement of Copper Slag as Fine Aggregate" Journal of Civil Engineering and Urbanism Volume 3, Issue 4(176-182).

STRENGTH AND DURABILITY PROPERTIES OF COPPER SLAG …

An experiment was conducted to investigate the strength and durability properties of concrete having copper slag as a partial replacement of sand (fine aggregate) and results have been presented in this paper. Two different types of Concrete Grade (M20 & M30) were used with different proportions of copper slag replacement (0 to 50%) in the concrete.

Copper slag as fine aggregate for high performance concrete

properties as CaO content increases or under activation of NaOH. Use of copper slag in concrete industry as replacement of cement or/and fine aggregates can have the benefit of reducing the costs of disposal and minimising environmental pollution [1,2]. Little research work has been conducted to investigate the potential use of copper slag as ...

Effect of copper slag as fine aggregate replacement in ...

Jan 01, 2019· The fine aggregate which was used in the concrete was locally available and collected from the Tungabhadra River. The following tests were conducted on the fine aggregate. Physical properties comparison between Sand and Copper Slag shown in Table 6.